Roving Networks FIREFLY RN-422 Manual de usuario descargar pdf (Pagina 5)

www.rovingnetworks.com 5

RN-BT-SRL-UM-1.0

CONFIGURATION SWITCHES

The adapters have small configuration switches on the top. You need a paper clip or small screwdriver to flip them.

Holding the adapter with the DB9 connector facing to the right, refer to Figure 1 for the switch numbering and on/off

positions.

Figure 1. Switches

Table 3 describes the functions controlled by the switches.

Table 3. Switch Functions

Switch

Function

Description

Restore factory defaults

Turn on the switch, power up the adapter, and toggle the switch ON-OFF-ON-OFF-ON

to return the adapter to its factory settings. The green LED blinks quickly for a moment

and then continues to blink about once per second.

Automatic discovery

In slave mode, this switch sets a special class of device that is used by the master to

auto connect. If switch 3 also turned on, the adapter performs a search, stores, and

connects to a remote Roving Networks Bluetooth device that has switch 2 turned on.

Automatic master

With this switch turned on, the adapter acts as Bluetooth master and auto-connects to a

stored remote address. You must first set the Bluetooth address of the slave device

using the SR command or using instant cable replacement settings.

Default baud rate

With this switch turned off, the default 115 K baud rate is overridden by software baud

rate configuration commands. If this switch is turned on, the baud rate is 9600 and the

adapter ignores the software configuration.

On O

RN-270 & RN-274RN-240, RN-422 & RN-220-XP

On O

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Roving Networks FIREFLY RN-422 Manual de usuario Pagina 5